I am starting with this blog series in which I will be detailing the steps of NSX-T installation in my lab environment which will be later used for PKS installation and integration..
In Part1 , I am deploying NSX manager followed by 3 NSX controllers and connecting them to NSX manger. This deployment is based on the latest NSX-T release 2.2 and currently on ESXi. I will be adding KVM transport nodes to the setup at a later stage.
I have downloaded NSX-T manager 2.2 OVA for ESXi and NSX-T controllers OVA for ESXi from VMware website : https://my.vmware.com/web/vmware/details?productId=673&downloadGroup=NSX-T-220
In my lab, I have 4 ESXi nodes running VSAN on which the deployment will proceed. I have created 5 nested ESXi host will be used as transport nodes for the NSX-T deployment.
Deployment of NSX-T manager is pretty straightforward ova deployment which will require IP address, DNS, NTP entries. After the deployment of the NSX manager booting up, we can login into the NSX-T manager, and check the status of the interface.
After the NSX-T manager is deployed , its time for NSX-T controllers to be deployed. Again, NSX-T controllers for ESXi are OVA as well and then 3 of them are deployed on ESXi as below.
After the NSX-T controllers are deployed, we need to confirm its reachability to NSX-T manager before we can go ahead with the steps of connecting controllers with NSX-T manager.
Connect to NSX-T manager SSH, and run the below command to get thumbprint:
#nsxt-mgr > get certificate api thumbprint
After that, connect using SSH to each of the NSX controller’s and run the below command:
#nsxt-controller1 > join management-plane NSX-Manager-IP-address username admin thumbprint <NSX-Manager-thumbprint>
After joining the NSX-T controllers to the NSX-T manager, verify the result by running the “get managers” command.
On the NSX-T manager , run the below command to check that NSX controllers are listed.
Once, all the NSX controllers are connected to NSX manager, then a NSX-T controller needs to be set as the master and the control cluster needs to be initialized.
- Open an SSH session for your NSX Controller.
- Run the set control-cluster security-model shared-secret secret <secret> command and type a shared secret when prompted. Ensure you remember the secret key.
- Run the initialize control-cluster command.
This command makes this controller the control cluster master
After this , get the control-cluster status and verify that master is in majority are true and the status is active and the zookeeper server IP is reachable.
Post which we need to join the other controllers to the master.